Skip to content
Toronto PlumbingService Call(365) 389-6437
A renovated bathroom with vanity, fixtures and tile
A renovated bathroom with vanity, fixtures and tile.

The Manual: Drains

High-Pressure Drain Jetting in Toronto

A cable punches a hole. A jet of water scrubs the whole pipe. Knowing the difference saves you a second call.

  • A written note of what changed and why
  • Shut-off help by phone before the truck arrives
  • Choices laid out plainly so you pick the fix
  • Parts matched to the pipe already in your walls

Licensed & insured · details on request

  • 24/7Response line: a plumber answers, day or night
  • 27Areas covered, from the old city to the suburbs
  • 35Services for homes, condos and businesses

Signs you need this fixed

  • Grey ring around the basement floor drain
  • Water standing in the tub after a shower
  • Gurgle from the sink when the toilet flushes
  • Washer drain spitting back up the standpipe

What jetting does differently

A jetter sends water down a reinforced hose under heavy pressure. Its nozzle carries rear-facing jets, which drive it forward up the pipe while scouring the wall all the way around. Grease, sludge, scale and fine roots break off and wash downstream. Where a cable leaves a ring of build-up behind, a jet takes the pipe back to near its original bore.

Lines that suit jetting

  • Restaurant and kitchen lines loaded with grease.
  • Main drains that keep clogging with fine sludge after cabling.
  • Long horizontal runs in condos and commercial basements.
  • Storm and weeping tile lines that have silted up.
  • Lines with fine root hair after a mechanical cut.

Jetting is also a good way to prepare a pipe before it is lined or before a careful camera inspection, since the camera can see the actual pipe wall.

When it is not the right tool

Fragile pipe is the main concern. Orangeburg fibre pipe, clay with missing sections, or cast iron that is rusted through can be damaged by high pressure. We always look first, either with a camera or from what a cable brings back, before choosing pressure and nozzle. A solid object, like a toy or a hardened mass of wipes, is better pulled with a cable. And jetting a line that has collapsed only moves water around; it cannot fix a break.

Not a pressure washer. Rental pressure washers are built to clean decks. Drain jetters use a different hose, nozzle and flow rate designed to move through pipe safely.

What the visit looks like

We find access, usually a cleanout near the foundation or a roof vent for stacks, and protect the area. The hose is fed in, pressure is brought up gradually, and the nozzle works its way out to the City connection and back. Most residential runs take under an hour. We finish with a camera look so you see the result and know the condition of the pipe for the future.

What is included on the visit

Tools on the truck

  • Sectional machine with root cutter for the main
  • Drop-head hand auger for sink and tub branches
  • Drum machine with 3/8" cable for trap arms and stacks

What we open

P-trap, cleanout plug or the floor drain grate

How we test it

Fill-and-drop test on every fixture on the branch

How the job runs

  1. Ring the line

    Say what is dripping, backing up or banging. Water still flowing? We guide your hand to the valve first.

  2. Find the cause

    The plumber traces the fault, with a scope or gauge where one earns its keep.

  3. Pick the fix

    Options come in everyday language, and nothing starts until you choose.

  4. Repair & prove it

    We finish, run the water to prove it, wipe up and leave a short written record.

Calls we field, answered plainly

Does jetting use a lot of water?

Less than you might think, usually a few hundred litres for a house line. It all goes down the drain being cleaned.

How long do results last?

Far longer than cabling for grease and sludge. Roots will still regrow through open joints.

Keep reading on this site

Call now · (365) 389-6437